The Capabilities of a Traditional QCM at a Fraction of the Size and Cost
The new INFICON Q-pod transducer is a small, inexpensive, accurate way to measure thin film deposition rate and thickness. Setup and operation couldn't be easier. Connect the Q-pod BNC connector to the signal cable from a QCM sensor. On the other side, a standard USB cable connects to your PC. No external oscillator or power source is required. Load the free Q-pod software on your PC and you're ready to go. Q-pod software displays rate, thickness, frequency, crystal life, and a graph of rate versus time, for up to 8 Q-pods simultaneously. Q-pod readings can be logged to disk in spreadsheet friendly comma-delimited format.
Features at a Glance
- Simplest and least expensive QCM available anywhere
- Connect directly to your PC's USB ports - up to 8 Q-pods
- Windows-based software included for operation and data logging
- Weighs less than 2 ounces and small enough to fit in a shirt pocket
ASSOCIATED TECHNICAL INFORMATION
Brochures and Datasheets:
 |
Brochure - Q-pod Quartz Crystal Monitor
English
|
Operations and Maintenance Manuals:
|
|
Operating Manual - Q-pod Quartz Crystal Monitor
English
|
Software:
 |
Software - QPOD_SETUP_V1.09
English
|
|
|
